Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Arduino 2.4" TFT Shield
04-26-2015, 06:44 PM, (This post was last modified: 04-26-2015, 06:49 PM by aart.)
#1
Arduino 2.4" TFT Shield
I purchased on banggood.com an Arduino Uno with a 2.4" TFT Shield.
In this thread I will write down my findings.

1: Connections
The connections at the bottom, which can be placed on the Arduino Uno are listed as follows:
(The left side is the connection of the LCD, right side, the connection of the Arduino Uno.

Left top-to-bottom:
NC
LCD RST == A4
LCD_CS == A3
LCD_RS == A2
LCD_WR == A1
LCD_RD == A0
----
NC
GND == GND
GND == GND
5V == 5V
3.3V == 3V3
RESET == RESET

Richt Top to bottom:
NC
NC
LCD_D2 == D2
LCD_D3 == D3
LCD_D4 == D4
LCD_D5 == D5
LCD_D6 == D6
LCD_D7 == D7
----
LCD_D0 == D8
LCD_D1 == D9
SD_SS == D10
SD_D1 == D11
CD_D0 == D12
SD_SCK == D13
NC
NC
Reply
04-26-2015, 06:51 PM, (This post was last modified: 04-26-2015, 06:54 PM by aart.)
#2
RE: Arduino 2.4" TFT Shield
Software:

I found the following software library: TFT_Shield.zip.

After adding this software to the Arduino workbench and moving the libraries in the correct place, I could run the graphics test which is included in the TFT_Shield.zip as an example.


Attached Files
.zip   TFT_Shield.zip (Size: 423.04 KB / Downloads: 0)
.zip   F10HAYOI5S2FPRE.zip (Size: 66.54 KB / Downloads: 1)
Reply
05-22-2015, 05:32 AM,
#3
RE: Arduino 2.4" TFT Shield
I found the datasheet of the chip used.

From this I am building my own library.

The datasheet is attached to this forum entry.


Attached Files
.pdf   ILI9341.pdf (Size: 3.37 MB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)